USD
Spindle not getting 10 volt for GSK980TDi
GSK980TDi User:
This email is regarding the speed of the cnc is not the same of the cnc control, let me show you the parameters setup and the result:
Parameter 001 bit 4=1
Parameter 021 =1000
Parameter 036=0
Parameter 037=9999
Parameter 067=10000
In MDI I input M3 S9999
With this configuration I should have a reading of 10volts in the spindle drive and I only have .687v.
What should I set in order to have 10v in the analog output?
CNCmakers support:
Are you using VFD for the spindle?
Please kindly set below parameters of GSK980TDi
195=0000000
220=s1=1，others=0
73=65535
75=0
This email is regarding the speed of the cnc is not the same of the cnc control, let me show you the parameters setup and the result:
Parameter 001 bit 4=1
Parameter 021 =1000
Parameter 036=0
Parameter 037=9999
Parameter 067=10000
In MDI I input M3 S9999
With this configuration I should have a reading of 10volts in the spindle drive and I only have .687v.
What should I set in order to have 10v in the analog output?
CNCmakers support:
Are you using VFD for the spindle?
Please kindly set below parameters of GSK980TDi
195=0000000
220=s1=1，others=0
73=65535
75=0
