GSK980TDb PLC alarm
PLC alarm(standard PLC ladder definition of GSK980TDb)
Detail GSK980TDb specifications:
http://www.cncmakers.com/cnc/controllers/CNC_Controller_System/GSK980TDb.html
Number | Content | Address |
1000 | Tool change time is too long | A0000.0 |
1001 | Alarm of toolpost not in-position at the end of tool change | A0000.1 |
1002 | Alarm of tool change not finished | A0000.2 |
1003 | Can’t execute M10 and M11 under invalid tailstock function | A0000.3 |
1004 | Can’t retreating tailstock when spindle rotating | A0000.4 |
1006 | Can’t start cycle when cycle start enabling is closed | A0000.6 |
1007 | Can’t start the spindle when thespindle start enabling is closed | A0000.7 |
1008 | Tailstock function is invalid, M10 and M11 cannot be executed | A0001.0 |
1009 | The thread run-out cannot be executed in spindle rotating | A0001.1 |
1011 | Have not checked the tailstock forward and cannot start the spindle | A0001.3 |
1012 | Tool change mode A and B can have up to 8 tools | A0001.4 |
1015 | Confirm the tool quantity of the tool post (6,8,10,12) | A0001.7 |
1016 | Alarm of protection door not closed | A0002.0 |
1017 | Chuck low pressure alarm | A0002.1 |
1019 | Can’t unclamp chuck when spindle rotating | A0002.3 |
1020 | Alarm of invalid clamping in-position signal when spindle rotating | A0002.4 |
1021 | Can’t start spindle when clamping in-position signal | A0002.5 |
1022 | Can’t start spindle when chuck is unclamped | A0002.6 |
1024 | Can’t execute M12 or M13 under invalid chuck function | A0003.0 |
1025 | Have not checked chuck clamping/releasing in-position signal | A0003.1 |
1032 | Illegal M code | A0004.0 |
1033 | Spindle jogging function is invalid under invalid analog spindle | A0004.1 |
1034 | Setting error for M03 and M04 | A0004.2 |
1037 | Spindle speed/position control switch time is too long | A0004.5 |
http://www.cncmakers.com/cnc/controllers/CNC_Controller_System/GSK980TDb.html