Model GDL80-20-24Z/2.2 (PDF file click to download)
Model GDL80-20-24Z/2.2
Voltage 220 V
Power 2.2 kw
Current 7.6 A
Frequency 800 Hz
Rotating speed 24000 rpm
Pole number 4P
Phase number 3
Rotating direction Rotate anticlockwise
from the shaft
extension end
Tool holder IS020 (Parfaite is
recommended)
Blind rivet IS020-15° (Parfaite
is recommended)
Weight 8 KG
1: Power line Three-color lines connected with U,
V and W phases/ yellow and green wires grounded
Temperature control line 110°C thermistor two-phase
connected with the temperature-control protector
2: Cooling water feed Pump lift 8m
3: Pole change and dust removal pressure
0.2-0,3Mpa (6/4 hoses)
4: Quantity of proximity switches Pole hanging
and pole discharge NPN (normally open) N.O.
Wiring method of the proximity switch Brown wire
connected with +24VDC blue wire connected with 0VDC
Signal load end connected with +24VDC/the other end
connected with the black wire
5: Air seal pressure 0.1-0.2Mpa (4/2 hoses)
6: Cooling water yielding (2 and 6 ends terminated
with 8/6 hoses)
7: Air inlet pressure of the cylinder 0.65Mpa (6/4 hoses)
Special warning:
1. The electric main shaft shall be installed at the clamped position;
otherwise the bearing will be easily damaged!
2. The main shaft shall entirely stop before the tool changing. The
manual tool changing button shall not act during the rotation of the
shaft; otherwise it will easily result in the seizure of the shaft!
3. The compressed air shall be clean and dry, and the filter
accuracy shall be 0.1micron! Air seal is normally open. It is
recommended to use the two-level filter, and the filter accuracy is
0.5 micron/ 0.1 micron respectively. The air filter is installed with the
self-discharge device.