AC servo driver Err13 alarm
AC servo driver alarms Err13 means it is overloaded.
Causes:
Solutions:
Causes:
- One of the U, V or W open circuit.
- AC servo driver is not matched with the AC servo motor.
- The torque of the AC servo motor is not big enough.
- AC servo driver is broken.
Solutions:
- Check the cables.
- No.1 parameter of the AC servo driver is match with the AC servo driver or not? If not please set it right then recovery the default parameters.
- Check machine load, is it too heavy?
- Reduce the start and stop frequency, or increase the acceleration-deceleration time constant.
- Replace a bigger AC servo motor & driver.
- Send back the AC servo driver to repair.